Skip to content
  • +49 7145 / 93 508 - 0

  • Elly-Beinhorn-Str. 4 / D-71706 Markgröningen

Automation that turns tubes into precise rings

SPINNER TTS with automation

Requirement:

  1. Production of narrow rings from a large, long tube
  2. Processing of tube lengths of up to 1.4 metres
  3. Flexible handling of both the tube and the individual cut rings
  4. Cleaning of the finished parts after machining
  5. Separation of good parts and offcuts (waste) at the start and end of the tube
  6. Automated stacking and depalletising of the finished rings into end-customer crates

Considerations:

  • Use of a large SPINNER TTS lathe in combination with robotic automation
  • Feeding of the tubes via a conveyor belt directly into the system
  • Automatic gripper-changing system on the robot for different tasks: large gripper for handling the tube, smaller grippers for clamping the rings from the inside and outside
  • Machine with a large spindle centre distance to accommodate tubes up to 1.4 m in length
  • Special clamping devices for simultaneously clamping the tube and individual rings during cutting, thereby providing support to ensure parallelism
  • Washing station for cleaning the finished parts
  • Separate discharge of offcuts for easy removal by the operator
  • Stacking of the rings in KLTs and automated removal via a palletising module

Solution:

Cost-effective production is achieved through a high-performance combination of a large SPINNER TTS lathe and a sophisticated robotic automation system. This enables the entire process – from the pipe to the finished, cleaned and depalletised ring – to be carried out within a single, integrated production cell.

At the start of production, the operator places the tube on a conveyor belt, scans the work order, and the tube is transported into the system. There, the robot takes over further handling. A gripper-changing system allows it to switch flexibly between different tools: a large gripper is used to move the tube, whilst smaller grippers clamp the inside and outside of the rings that have already been cut off.

The robot loads the tube into the SPINNER TTS. Special clamping devices enable the tube to be clamped whilst simultaneously securing each ring individually, so that it can then be cut off with precision.
After the turning operation, the robot picks up the part again and feeds it into a washing station. Here, it is rinsed, then dried with hot air, and finally the finished ring is depalletised by the robot. The offcuts from the start and end of the tube are discharged separately as waste and can be easily removed by the operator from outside the machine.

In this way, a single tube is used to produce numerous individual rings. The robot stacks these into KLTs, which are then automatically removed via a palletising module.

The project impressively demonstrates how many individual process steps – from loading through machining, clamping, cutting, washing right through to palletising – can be integrated into a seamlessly functioning complete system. This is precisely what sets SPINNER automation apart.

Let's get started!

CONSULTING & CONTACT

Cedric Scheel

Project Manager Sales

07145 93508-34

E-Mail

Markus Götz

Project Manager Sales

07145 93508-36

E-Mail